T24004 - 1/24 Scale Complete Chassis Kit
View Larger

T24004 - 1/24 Scale Complete Chassis Kit

$59.95

Complete chassis kit with motor, wheels, tires & traction magnet, for use on plastic track.

1/24-Scale Home-Racing Chassis in Ready-to-Race form For Use on Carrera, Revell, Monogram and most 3.5" lane-spaced plastic tracks. One traction magnet is supplied with each chassis and its use is recommended with stock tires. The use of a 2-amp variable voltage power supply and PM electronic controllers is highly recommended (please check our controller catalog).
Note: to use this chassis on Ninco track, the metal guide pin must be shortened and narrowed. This chassis comes with 2 types of body mounts. We recommend the use of the Automatic Body Mounting Tool, part # T3207 when using the pin-tubing mounts. The chassis is fitted with the TSC25 guide pin. The chassis is supplied with Gevon rubber tires suitable for plastic tracks for use with traction magnet. If used without a traction magnet, we recommend the use of THP3212 rear tires.

1/24-Scale Home-Racing Chassis in Ready-to-Race form For Use on Carrera, Revell, Monogram, Atlas and most 3.5" lane-spaced plastic tracks. One traction magnet is supplied with each car and its use is recommended with stock tires. The use of a 2-amp variable voltage power supply and PM electronic controllers is highly recommended (please check our controller catalog).
The chassis comes with 2 types of body mounts. We recommend the use of the Automatic Body Mounting Tool, part # T2407 when using the pin-tubing mounts. The chassis is fitted with the TSC25 guide pin. The cars are supplied with Gevon rubber tires suitable for plastic tracks for use with traction magnet. If used without a traction magnet, we recommend the use of THP2407 or THP2408 rear tires.

For use on Ninco track or any track with raised contact rails, TSR recommends that up to two traction magnets be used and covered with black electrical tape. For Ninco or Scalextric "Classic" track with shallow and narrow slot, use a TSC25N special guide pin, or the standard guide pin must be shortened and narrowed with a Dremel disk.

 


  • Shipping Weight: 1lbs

Add to Cart:



This product was added to our catalog on Sunday 23 May, 2010.

if you have to think ... you haven't been Zenned!